8mm 20T PULLEY/DISK HOLDER

R0424

New updated pulley/disk holder for the IF18-3 with longer size pins.

The adhesive thickness of the brake pads caused interference between the brake pads and the pulley holder. Therefore, clearance has been adjusted.

The revised parts can be used with the old kit as is, but recommend checking the following points just to be sure.

Check compatibility: Check whether the revised parts can be combined without any problems with other parts from the old kit.

Recheck the clearance: Check that the adjusted clearance is appropriate and within a range that does not affect safety or performance.

Test run the inspection: Operate the kit and check for any abnormal noise, vibration, or change in braking force.